Protractor - Configuring Inspection Results For DVI Insert

Protractor - Configuring Inspection Results For DVI Insert

This process must be done while logged into Protractor as an admin level account

  1. In Protractor select the Settings from the primary Home menu
  2. Navigate to the Inspection Results category, easily found by searching for 'Inspection'
    1. The Code and Labels (Displayed within Protractor itself) can be any configuration preferred, however the Value of the three results to be inserted from autoflow must match the values below exactly.
      1. OK ( Good/Green Check Items)
      2. Suggested (Requires Future Attention/Yellow Exclamation Items)
      3. Requires (Requires Immediate Attention/Red X Items)

  1. Any DVI Pushed from autoflow to Protractor after this configuration is confirmed will now populate the Inspections tab in a Protractor visit with the selected status marked.

Be advised that Protractor visits will not update while a ticket is open, and may overwrite any results pushed from autoflow with older information.


    • Related Articles

    • Protractor Inspection Package Mapping for DVI Sheets

      In order to map your saved Protractor inspections over to an Autoflow DVI, follow the steps listed below: 1. Create or locate the Protractor Inspection you would like to map to Autoflow. Double-click into the inspection if you are using one that has ...

    • Edit Locked DVI/ Duplicate and archive DVI's.

      If you have this message in you DVI sheet set up page; And would like to edit that DVI sheet OR if you simply want to duplicate and archive that sheet, follow these steps. 1. Under your admin log in for the ATMe dashboard use the drop down menu and ...

    • RVH and WO notes push-back with Protractor

      This parameter in Protractor MUST BE SET for notes to push back. Please verify this, before reporting an issue. RVH and WO notes do not push back to Protractor unless this key is setup.. There is one additional parameter to "toggle" this on. In the ...

    • Workflow Setup - Protractor

      To first access this page you will need to be logged into autoflow using an admin role profile. (These setup options will not be available to Service Writer or Technician profiles) From the top right drop down menu you would select the Workflow Setup ...

    • Tire Inspection Sub Statuses

      New Tire Inspection Sub Statuses: Instructions: To use sub-statuses in Autoflow's Multi Axle Tire Inspection, follow this guide. Step 1: Goto DVI Sheet Setup and click the Tire Inspection edit button. Step 2: Click Add Status Step 3: Click a symbol ...